Cincinnati Vmc 750 Manuals Solution Is

Guyson Shotblast Cabinet 850 REF: 3289 Guyson Guyson Shotblast Cabinet, Model Super 4, sn 48318W, Internal dimensions 700 x 600 x 400mm high, complete with dust extractor, rotary table.

Iemca VIP70 Short Mag Bar Feed Call for Price REF: 9072 Iemca 2000 Iemca VIP70 Short Mag Bar Feed, 2000, sn0200047005, cap 5-70mm dia, length of bar 150-1615mm.

Burgess Hill, West Sussex, RH15 8QY T: 44 (0) 1444 245414 F: 44 (0) 1444 247518.

Sir Winston Leonard Spencer Churchill (1874-1965) Peace is that brief glorious moment in history when everybody stands around reloading.

Anyway I was running a program and I accidently had my offset on the Z wrong and I crashed the spindle into some aluminum that I was getting ready to machine on.

I hit the estop and powered the machine off as soon as it hit.

I turned the machine back on and every time I try to turn the spindle on I get an error that says spindle drive fault 16541 I am so frustrated, does anyone out there know what to look for It has the acramatic 850 controller.

Is there some kind of a reset on the drive How can I check it I can hear the drive trying to do something but no spindle movement at all.

The spindle turns freely by hand and nothing broke or anything like that mechanically.

Could the ring sensor on the spindle have anything to do with it.

It seems like to me that if the spindle stalled out when it hit the aluminum on the table that it would have some kind of overcurrent protection.

Cincinnati Vmc 750 Manuals Solution Is

The manuals solution is to turn the machine off at the main disconnect, wait a few seconds and then power back up.

Simply turning the machine off with the master stop push button isnt always enough as is does not power down the control logic on the spindle drive.

Unknown Murphys Law: If it can go wrong it will O-Tools Corollary: Murphy was entirely too optimistic.

I did turn it off at the main breaker.

All night. I have tried everything.

I checked all the little fuses on the drive board, pushed all the resets on the whole machine and nothing.

Could I have bundt something up on the board by to much over current or something thanks.

Jeremy.

If one of these is blown it causes the motor to lose a phase.

This board is the large green board that the other boards mount on top of.

Also there is a 4 segment display on the drive, can you see what it is reading you have to sorta look up under a board to see it.

It is a Funuc drive so you can call their tech support and they are pretty good at helping you sort thru something.

I can the drive trying to do something but no movement out of the spindle.

I am so frustrated.

I thought I had it licked with those fuses.